The ball mill has a high degree of automation and can grind continuously. Each structural component can give full play to its own advantages to complete the grinding operation of the equipment. That is, the quality of any part of the entire fuselage is good, which makes the quality of the entire equipment reach high quality, thereby reducing the probability of component damage during the production process of the equipment. The cost of the ingredients required in the production process is very low, and this advantage saves a lot of capital investment for enterprise users. So how to control the feeding speed of the ball mill, what should be paid attention to?

1. Before the formal grinding operation, the equipment needs to be tested for no-load trial operation, and all problematic parts inside the equipment should be checked in advance to ensure the smooth production of the equipment.

2. In order to prevent the ball mill from being blocked during operation, it is necessary to control the feeding speed and feeding amount so that the entire feeding process is continuous, moderate, uniform and orderly, because once the feeding speed is too fast, the material in the cavity will not be completely discharged, and there will be material backlog and operation will not move due to the addition of new materials. Slowly over time, the equipment will be blocked by the material.

3. Prevent the conveyor belt from deviating or falling off, and remember that there is material leakage into the cracks of the conveyor belt, that is, prevent residual material on the conveyor belt. Although these materials may not look noticeable, they are the main culprits that cause the conveyor belt to deviate from its conveying track. Therefore, workers need to be careful when operating. Once residual materials are found, it is important to find an appropriate time to clean them up to avoid causing greater losses.